BeeGFS v7.2.7 Upgrade Guide¶
Please read and understand the information below completely before attempting the upgrade.
Possible upgrade paths¶
- The following upgrade paths from older versions are supported:
v2014.01 ⟶ v6.19 ⟶ v7.2.7
v2015.03 ⟶ v6.19 ⟶ v7.2.7
v6.x ⟶ v7.2.7
v7.x ⟶ v7.2.7
When upgrading from v2014.01 or v2015.03, an intermediate step is required. Upgrade to v6.19 by following the upgrade instructions in the Wiki under https://www.beegfs.io/wiki and/or the respective upgrade notes under https://www.beegfs.io/release. After that, start the management daemon at least once. You can then proceed with procedure below.
An upgrade from v7.2 beta1 or beta2 is not supported.
Upgrade to v7.2.7¶
A backup of the system after stopping all services and before upgrading packages from versions older than 7.2 is recommended.
All buddies have to be in the
GOOD state before upgrading to this release.
If you use buddy mirroring, make sure that all buddies are in
- Stop the BeeGFS system:
stop/unmount all clients
stop all storage daemons
stop all meta daemons
stop the management daemon
Create a full BeeGFS backup if possible, backup the configuration files of all servers (see Backup).
Upgrade all BeeGFS packages.
Check the configuration files. Some configuration options are no longer valid and have to be removed (see Release Notes v7.2.7).
Start all daemons and clients and verify that the system works as expected.